Friday, 1 June 2018

5 Useful Tips to Replace Broken Cistern Levers

Improperly tightened cistern levels or handles are the common cause of flushing problems with toilets. Check whether your toilet is flushing completely and also see if you have a loose toilet handle. If it’s loose, you can tighten it easily with the help of an adjustable wrench.

51005001

Does your toilet run continuously? If yes, then make sure your toilet handle isn’t so tight. Again, if the nut on the toilet handle is too tight, the handle arm won’t fall into the resting position after flushing.

You need to make sure the handle has enough space to allow the arm to move freely. Tightened handles can be loosened using an adjustable wrench. If the toilet handle is broken, it will prevent the toilet from running and need a replacement.
syphon-diaphragm-washer-l0345o-127mm-5-0-oval-2732-p_1

If a toilet flush handle is badly worn, it looks unsightly and can be unhygienic. The cracks collect germs and become tough to clean properly. Replacing this flush handle will give your toilet a refreshing look. But how do you replace broken cistern levers?

Tip-1

Unscrew the retaining screw.

First remove the cistern lid and keep it aside in a safe place. You will need to unscrew the retaining screw on the syphon actuation lever – the back of the toilet flush handle and unhook the wire connector precisely.

macdee-motion-adjustable-syphon-10120045-toilet-cistern-fittings-1166-p_2

Tip-2

Remove the plastic retaining nut. 

To remove the plastic retaining nut, you need to hold the handle in one hand. You should use an adjustable wrench to remove the plastic retaining nut.

Tip-3

Remove the handle.

You should remove the broken flush handle, lever, and wire connector to replace them with the new one.

Tip-4

Install a new handle. 

You should hook the wire connector onto the cistern lever and pull it slightly upward direction to tension the syphoning mechanism. You need to insert a new handle through the toilet and hold the handle at the right flush syphons starting position while pushing the square axle into the lever. After that, you need to tighten the lever retaining screw and handle retaining nut.

Tip – 5

Check the new handle.
sottini_reprise_chrome_lever
Replace the cistern lid. You need to check whether the toilet flushes perfectly. You should inspect the handle and find out whether it’s in the right position.

metro-rapid-oblong-siphon-2621-p_1

Conclusion –

Looking to buy cistern spares online? Choose no other than My Toilet Spares. Sometimes you may be quite unsure what type of cistern levers will be ideal for your toilet or perhaps you have an older toilet whose original flush lever has been stopped working.

Check out the available cistern handles, cistern lids, cistern levers at My Toilet Spares and make the selection that specifically fit your toilets at the best. For more information you can stay connected with us on our facebook , twitter  and google+ pages .

No comments:

Post a Comment